Hello,
I bought one of Alan To's WB controllers but am to the point where I've realized the connector on my WB sensor is different than what was supplied in the kit. I have a Bosch 17033 sensor from what I can tell and it uses a square 6-pin connector. The harness side uses a connector with a gray latch mechanism. Does anyone have the pinout information for this connection or a cross between this connection and the more conventional "D" shaped connectors that seem more common?
I've emailed Alan, but I haven't seen a reply yet. I'm in a bit of a rush as I am trying to get this done tomorrow (8/28) so any help appreciated.
CSR
Bosch LSU4.2 with square connector
Re: Bosch LSU4.2 with square connector
Apologies for the delay in authorising the post. Hopefully you got it sorted. There's only a few wires, so reverse engineering it shouldn't have been too hard in a total absence of online info.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: Bosch LSU4.2 with square connector
I figured it out. The pinout is the same as the more conventional 'D' shaped connector.
I'm up and running.
I'm up and running.
Re: Bosch LSU4.2 with square connector
![Image](http://stuff.fredcooke.com/like.jpg)
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!