Just accidentally started doing a load with rip, I want an abort button too! I hit about a few times before I realised it wasn't abort... lol. move about to a tab as johntramp suggested, and put abort in there for canceling a load gone wrong :-)
also the buffer stuff that you're aware of via irc.
I hope the wedding went flawlessly.
Fred.
FreeEMS-Loader
Re: FreeEMS-Loader
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: FreeEMS-Loader
I used the loader to load the code that ran the truck, the second FreeEMS vehicle! :-)
Are you next??? Or Marcos??? :-)
Fred.
Are you next??? Or Marcos??? :-)
Fred.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: FreeEMS-Loader
I'm currently using 6db3d838f9956... hash loader with much success. The following is a list of minor issues and improvements to be made on it:
loader - if pull cable, cant disconnect, cutecom does it automatically
loader - reset from freeems
loader - ditch boost and/or reduce delay at startup +1
loader - ace, verifyduring, verifyafter, verify against file
loader - add cancel during load
loader - proper greying out of buttons, unsure, but this could already be done.
loader - second or later load, clear from 100% to zero before erase bar starts
loader - show one bar at beginning of loader bar graph stuff such that user gets early feedback
loader - make bar graphs more granular instead of in chunks
Hopefully we can get some of these sorted very soon.
Fred.
loader - if pull cable, cant disconnect, cutecom does it automatically
loader - reset from freeems
loader - ditch boost and/or reduce delay at startup +1
loader - ace, verifyduring, verifyafter, verify against file
loader - add cancel during load
loader - proper greying out of buttons, unsure, but this could already be done.
loader - second or later load, clear from 100% to zero before erase bar starts
loader - show one bar at beginning of loader bar graph stuff such that user gets early feedback
loader - make bar graphs more granular instead of in chunks
Hopefully we can get some of these sorted very soon.
Fred.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: FreeEMS-Loader
I'm running the latest commit from tonight and it worked on the mac, but there are some issues.
It's usable, IF I'm careful.
Fred.
It's usable, IF I'm careful.
Fred.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
- SleepyKeys
- LQFP144 - On Top Of The Game
- Posts: 549
- Joined: Mon Feb 11, 2008 10:52 pm
- Location: Arizona
- Contact:
- DeuceEFI
- LQFP144 - On Top Of The Game
- Posts: 578
- Joined: Thu Feb 25, 2010 3:57 am
- Location: Gosport, IN USA
- Contact:
Re: FreeEMS-Loader
Here is a copy of the file I loaded with the Windows FreeEMS_Loader.exe and the rip of the firmware from the Jaguar board...
- Attachments
-
- FreeEMS-0.2.0-SNAPSHOT-152-g06ec3f1-DEV-EvenTeeth-Both-3and1-RIP.zip
- firmware .s19 file and ripped .s19 file
- (80.54 KiB) Downloaded 1153 times
Andy.
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
FreeEMS vehicle #11, 1932 Ford 5 Window Coupe with a 1996 GM 3.1L SFI V6 with DIS ignition
FreeEMS vehicle #16, 1996 Chevrolet S10 2.2L SFI I4 with DIS ignition
Owner of http://www.coolefi.com
Re: FreeEMS-Loader
Looks good! :-)
http://powerefi.com/files/FreeEMS_Loader-installer.exe
[00:17] <FreeAir> [23:52] <FreeAir> also
[00:17] <FreeAir> ends of lines will be filled with blanks in the rip
[00:17] <FreeAir> FF is blank
[00:18] <FreeAir> and
[00:18] <FreeAir> the bit near the SM
[00:18] <FreeAir> is just wrapped differently
[00:18] <FreeAir> so
[00:18] <FreeAir> it was succesful
http://powerefi.com/files/FreeEMS_Loader-installer.exe
[00:17] <FreeAir> [23:52] <FreeAir> also
[00:17] <FreeAir> ends of lines will be filled with blanks in the rip
[00:17] <FreeAir> FF is blank
[00:18] <FreeAir> and
[00:18] <FreeAir> the bit near the SM
[00:18] <FreeAir> is just wrapped differently
[00:18] <FreeAir> so
[00:18] <FreeAir> it was succesful
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
- SleepyKeys
- LQFP144 - On Top Of The Game
- Posts: 549
- Joined: Mon Feb 11, 2008 10:52 pm
- Location: Arizona
- Contact:
Re: FreeEMS-Loader
Hi,
Can someone give this one a try: http://powerefi.com/files/loader-installer-rc0.exe
This was built against the serialIOLib.
Thx!
Can someone give this one a try: http://powerefi.com/files/loader-installer-rc0.exe
This was built against the serialIOLib.
Thx!
You snooze, you lose!
Re: FreeEMS-Loader
Works! Just posting from Spanish win 64 starter in which i got 3% through a burn before falling asleep, waking up a few hours later, and aborting. I think it's the machine/driver not the app, so I'll fiddle more now.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
Re: FreeEMS-Loader
17.5 minutes for a normal load :-o first 11 minutes covered the first 33%, and this is WITH settings change from viewtopic.php?f=12&t=1844 plus lowering some latency to 1ms from 16 or something else in Spanish. Vids to come, for amusement.
DIYEFI.org - where Open Source means Open Source, and Free means Freedom
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!
FreeEMS.org - the open source engine management system
FreeEMS dev diary and its comments thread and my turbo truck!
n00bs, do NOT PM or email tech questions! Use the forum!
The ever growing list of FreeEMS success stories!